TA1045-1
$1,580.00
Engine Preheat Kit – 8 Cyl; IO-720 – 115V
Description
Engine Preheat Kit for 8 Cylinder; IO-720 series
This preheat kit contains threaded heat elements located in each cylinder assembly, and three pad heat elements (one on the engine crankcase and two oil sump). This multipoint configuration fully preheats the engine and attached accessories. Power is routed to the elements through a dedicated wiring assembly with system power indication and circuit overload protection. System is self-regulating through design. Heated components reach an average state of thermal equilibrium in approximately six hours.
This preheat kit is compatible with all engine monitor systems as the threaded heat elements can replace either a rocker cover screw or intake bolt fasteners.
This preheat kit when installed will supply 810 watts with a 7.0 amp draw at 115 volts
* Required Bonding sealant sold separately. Quantity 1, PN: TAU02788
Additional Information
Cylinder Piston/Radial: 8
Engine Manufacturer: Lycoming
Voltage: 115
USA-Cert (8130-3 available): PMA kit (Yes)
Old Part number: TAS100-19, TSP8CYL-1045-115
Downloads
To access any of our Downloads (Documents) below, you will need to login or register for an account.
-
Drawing - Kit (System)
- 1045-115, System Kit Drawing for 8 Cylinder 720 Lycoming 53.47 KB
-
System Install Instructions
- TNP1045, 8 Cylinder Kit Install Instructions for 720 Lycoming 993.09 KB
-
Operator's guide
- TFMS1045, Pilot Guide for 8 CYL 720 80.53 KB
-
ICA (Instructions for Continued Airworthiness)
- TICA1045, ICA for TSP8CYL-1045 kits 705.27 KB
-
Component Install Instructions
- TN02771, Thread Element Install Instructions (771 series) 2.78 MB
- TN02788, Bonding of Pad Element Install Instructions (was 186) 121.86 KB
-
Drawing - Cable Kit/Wire Diagram
- 02813, Cable Kit Drawing for 8 Cylinder 720 Lycoming 115.33 KB