TA3002-2
$2,580.00
Engine Preheat Kit – Jacobs R-755 – 230V
Description
Engine Preheat System Kit – Jacobs (L-4, L-5, L-6) series A1 R-755
This preheat kit contains threaded electrical resistance heat elements located in each cylinder assembly, and four pad heat elements on the engine crankcase, oil sump, and tank. This multipoint configuration fully preheats the engine and attached accessories for reduced wear on startup and reduced run-up times at any temperature. Power is routed to the elements through a dedicated wiring assembly with system power indication and circuit overload protection. System is self-regulating through design. Heated components reach an average state of thermal equilibrium in approximately six hours.
This preheat kit when installed will supply 750 watts with a 3.3 amp draw at 230 volts
* Required Bonding sealant sold separately. Quantity 2, PN: TAU02788
This kit is not eligible for an 8130-3.
* RTB0001 form required for purchase on certified engine installations.
Additional Information
Cylinder Piston/Radial: 7
Old Part Number: TSP7CYL-3002-230 TSP7CYL-3002-230
Engine Manufacturer: Jacobs
Voltage: 230
USA-Cert (8130-3 available): RTB (NO)
Downloads
To access any of our Downloads (Documents) below, you will need to login or register for an account.
-
Drawing - Kit (System)
- 03002-230, System Kit Drawing for Jacobs 755 98.41 KB
-
System Install Instructions
- TNP3002, 7 Cylinder Kit Install Instructions 1.30 MB
-
Operator's guide
- TPG0001, Operating Guide for Piston Airplane (FMS) (OM100) 364.13 KB
-
ICA (Instructions for Continued Airworthiness)
- TCA0001, ICA for Piston Airplane 548.86 KB
-
Component Install Instructions
- TN02788, Bonding of Pad Element Install Instructions (was 186) 121.86 KB
- TN02793, Instruction for DT series connectors (was 192) 329.80 KB
- TN02829, Circular Plug and Receptacle Install Instructions 812.54 KB
- TN02905, Generic Threaded Element Install Instructions.pdf 1.62 MB
-
Drawing - Cable Kit/Wire Diagram
- 02890, Cable Kit Drawing for Jacobs 755 251.47 KB