TA2461-1
$1,200.00
Engine Preheat Kit – Jabiru 3300 -115V
Description
Engine Preheat kit for 6 Cylinder; Jabiru 3300
NOTE: This kit is being redesigned and is currently a very long lead time.
This preheat kit contains threaded electrical resistance heat elements located in each cylinder assembly’s rocker cover, and one pad heat element bonded on the engine crankcase. This multipoint configuration fully preheats the engine and attached accessories. Power is routed to the elements through a dedicated wiring assembly with system power indication and circuit overload protection. System is self-regulating through design. Heated components reach an average state of thermal equilibrium in approximately six hours.
This preheat kit when installed will supply 280 watts with a 2.4 amp draw at 115 volts.
* Required Bonding sealant sold separately. Quantity 1, PN: TAU02788
Additional Information
Cylinder Piston/Radial: 6
Engine Manufacturer: Jabiru
Voltage: 115
USA-Cert (8130-3 available): N/A (NO)
Old Part numbers: TAS100-31-107-DT
Downloads
To access any of our Downloads (Documents) below, you will need to login or register for an account.
-
Drawing - Kit (System)
- 2461-115, System Kit Drawing for Jabiru 6 Cylinder 115 volt 227.67 KB
-
System Install Instructions
- TNP2461, Kit install instructions for Jabiru 3300 964.14 KB
- TNG1000, Installation Guide 5.38 MB
-
Operator's guide
- TPG1000, Operating Guide General Preheat Kit 353.41 KB
-
ICA (Instructions for Continued Airworthiness)
- TCA1000, ICA General Preheat Kit (all kits) 269.97 KB
-
Component Install Instructions
- TN02638, threaded heat element install instruction 2.65 MB
- TN02788, Bonding of Pad Element Install Instructions (was 186) 121.86 KB
- TN02793, Instruction for DT series connectors (was 192) 329.80 KB
- TN03039, LED Indicator Light Install Instructions 101.52 KB
-
Drawing - Cable Kit/Wire Diagram
- 02821, Cable Kit Drawing for 6 Cylinder Jabiru 153.45 KB