TA2925-2
$820.00
Engine Preheat Kit – 4 Cyl; Continental and Lycoming (STC) – 230V
Description
STC Engine Preheat Kit for 4 Cylinder Continental and Lycoming engines
FAA-STC: # SE03232CH
TCCA acceptance of FAA-STC on file.
EASA-STC: # 10054417
This preheat kit contains threaded heat elements located in each cylinder assembly, (intake bolt or rocker cover screw replacement) and one pad heat element on the engine crankcase/oil sump/tank. This multipoint configuration fully preheats the engine and attached accessories. Power is routed to the elements through a dedicated wiring assembly with LED system power indication and circuit overload protection standard. The system is self-regulating through design. Heated components reach an average state of thermal equilibrium in approximately six hours. Refer to our Frequently Asked Questions or Why Tanis or Contact us for additional information.
This preheat kit is compatible with all engine monitor systems as the threaded heat elements can replace either a rocker cover screw or intake bolt fasteners.
This preheat kit when installed will supply 240 watts with a 1.0 amp draw at 230 volts.
* Required Bonding sealant sold separately. Quantity 1, PN: TAU02788
Contact us for more information on Legacy systems that may be available.
“Not eligible for Rotorwing aircraft (helicopters).”
Additional Information
Cylinder Piston/Radial: 4
Old Part Number: TSP4CYL-2925-230 , TAS100-01*, TAS100-02*, TAS100-03*, TAS75-01*, TAS100-29*; *= any 230 volt dash number TSP4CYL-2925-230
Engine Manufacturer: Continental, Lycoming
Voltage: 230
USA-Cert (8130-3 available): STC kit (YES)
Downloads
To access any of our Downloads (Documents) below, you will need to login or register for an account.
-
Download All
-
Drawing - Kit (System)
- 02925-230, System Kit Drawing for 4 Cylinder STC 176.78 KB
- TA2925-2, HPI DRAWING REV F 80.65 KB
-
System Install Instructions
- TNP2925, 4 Cylinder Kit Install Instructions for Lycoming, and Continental 914.49 KB
- TNG1000, Installation Guide 5.38 MB
-
Operator's guide
- TPG1000, Operating Guide General Preheat Kit 353.41 KB
-
ICA (INSTRUCTIONS FOR CONTINUED AIRWORTHINESS)
- TCA1000, ICA General Preheat Kit (all kits) 269.97 KB
-
Component Install Instructions
- TN02771, Thread Element Install Instructions (771 series) 2.78 MB
- TN02788, Bonding of Pad Element Install Instructions (was 186) 121.86 KB
- TN02829, Circular Plug and Receptacle Install Instructions 812.54 KB
- TN03039, LED Indicator Light Install Instructions 101.52 KB
-
Drawing - Cable Kit/Wire Diagram
- 02859, Cable Kit Drawing for 4 Cylinder 256.08 KB
-
STC/PMA DATA
- SE03232CH, 4 Cylinder USA (FAA) STC with AML 382.40 KB
- 5010-14-0163, 4 Cylinder Canada (TCCA) STC Acceptance 173.12 KB
- 10054417, 4cyl EASA STC 1.69 MB
-
"DOWNLOAD ALL" FOR KITS BEFORE SERIAL NUMBER 53913 (NOTE: SMALL DOCUMENT CHANGES)
- ZIP TSP4CYL-2925-230 FOR KITS BEFORE SERIAL NUMBER 53913 16.43 MB